Metal Carved Panel

Metal carved panel (insulated wall cladding) 380mm wide, 16-30mm thick, aluminum-zinc coated steel face, B1(B) fire rating per GB 8624-2012. Factory-direct from Tianjin, China.

Overview

The metal carved panel is an insulated wall cladding combining decoration and insulation in one board: an aluminum-zinc coated steel face, a rigid polyurethane insulation core and a moisture-resistant aluminum foil backing. It is a common choice for exterior wall insulation and renovation.

With a variety of brick, stone, wood-grain and embossed finishes, the panel suits self-built houses, factory walls, old-building renovation and lightweight steel structures. Tongue-and-groove joints with sealant give a clean, concealed fastening.

Specifications

Face materialAluminum-zinc coated steel sheet (corrosion resistant)
Core materialRigid polyurethane (PU) foam insulation
BackingMoisture-resistant aluminum foil
Width380 mm
Thickness16 / 18 / 20 / 25 / 30 mm
Surface finishesBrick, stone, wood-grain and embossed patterns
Fire ratingB1(B) per GB 8624-2012 (test report available)
Weight (16mm)About 3 kg/m² — low load on walls
InstallationDirect to masonry with plastic expansion anchors, or on steel framing with self-tapping screws

Choosing Thickness & Core

  • 16mm — lightweight (about 3 kg/m²), low wall load; quick to install; well suited to renovation, interior decoration, light-steel villas, booths and projects with wall-load limits.
  • 18-20mm — balanced insulation and cost for general buildings.
  • 25-30mm — thicker insulation for projects with higher thermal requirements; rock-wool core versions available where higher fire resistance is required.

Installation

  • Solid masonry / concrete wall (recommended): fix panels directly with plastic expansion anchors — no steel frame required; tongue-and-groove joint + weather-resistant sealant.
  • Light-steel wall: install a steel frame first (studs no more than 600 mm apart), then fix panels with self-tapping screws spaced no more than 400 mm.
  • Use trim strips around doors and windows, and special corner profiles for inside/outside corners.

FAQ

What fire rating does the metal carved panel have?

The metal carved panel (insulated wall cladding) is rated B1(B) per GB 8624-2012, with the corresponding test report available. Rigid polyurethane core and EPS-core versions meet different project requirements.

How heavy is the 16mm panel?

The 16mm panel weighs about 3 kg per square meter, so it adds little load to the wall and can be installed by one worker.

Can it be installed directly onto a brick or concrete wall?

Yes. On solid brick or concrete walls, panels can be fixed directly with plastic expansion anchors — no steel frame needed. On light-steel walls, install a frame first, then fix the panels.

How long does it last?

With normal use, the panel is expected to last 20-30 years. The aluminum-zinc coated face and fluorocarbon coating resist weathering, and the surface shows no obvious fading within about 15 years under normal conditions.

Need Full Specifications or Samples?

Contact us with your project — samples, test reports and pricing available. Factory-direct from Tianjin.

WhatsApp +86 166 0260 0359 Email Us